Step 17 - Add Load Combinations

For our final model definition step, we will add a single load combination as follow:

1. Navigate to the 'Load Combinations' sheet in the Input Workbook
2. Click on 'Add' from the contextual ribbon
3. Leave the name as 'C1', set the 'Load Factor' for 'Load Case' 'DL' to '1.2'
4. Click '+' next to 'Add / Remove from Load Combo'
5. Select 'LL' from 'Load Case' dropdown, set the 'Load Factor' to '1.5'
6. Click '+' next to 'Add / Remove from Load Combo'
7. Click 'Apply'

We are now ready to run the structural analysis on this model in the next step!